Inserting a bobbin – SINGER 5160 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S I N G E R
Inserting a bobbin
DO NOT FORGET TO SWITCH OFF THE AAACHINE
WHILE WORKING IN THE BOBBIN AREA.
1. Lift presser foot.
2. Turn hand wheel toward your direction until
needle is in its highest position.
3.
Pull approximately 4” of thread from repla
cement bobbin and insert bobbin into case
(illustration 1).
Note: While unwinding, the thread should turn from
right to left (counter clockwise).
4. Holding bobbin in place, guide thread into slot A
(illustration2).
5. Guide the thread down the slot to the left around
to slot B (illustrations).
6. Close the bobbin visor partially allowing some
thread to come up and toward the back
(illustration 4).
38