Removing the shank, Changing a needle – SINGER 5160 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S I N G E R
Removing the shank
TURN OFF THE A^ACHINE BEFORE REMOVING THE
SHANK.
1. Turn hand wheel until the needle is in its highest
position and lift the presser foot.
2. Loosen the screw "A" and remove the shank pulling it
down.
3. To replace the shank "B" fit it around the presser bar
and tighten screw'A".
Changing a needle
TURN OFF THE A^ACHINE BEFORE CHANGING
NEEDLE.
1. Turn hand wheel until the needle is in its highest
position.
2. Loosen the needle clamp screw and remove needle.
3. With the flat side of needle to the back, insert new
needle up into clamp as far as it will go.
4. Tighten needle clamp screw firmly.
24