Beisler 100-68 - Manual (Page 120)

Machine parameters corner knives (basic adjustment)
In the program “machine parameters” the basic adjustment of the step
motors for the corner knives as to the seam is made.
Prior to the correction of the corner incisions a workpiece should be
prepared and sewn.
For this purpose proceed as follows:
–
Set the maximum sewing length at the control.
– Iron a piece of fleece on a workpiece.
Thus the corner incisions are better visible.
– Make a test seam.
– Check the seam pattern.
Stationary knives
Adjustable knives
NOTE !
As regards sewing units for straight pockets the icons 1 and 2 are
grey-shadowed and cannot be selected.
36
2 1