Beisler 100-68 - Manual (Page 58)

3.6.2 Opening stroke of the flap clamp
Caution: Risk of injury!
Switch the main switch off.
Check and adjust the flap clamp with utmost caution when the sewing
unit is switched on.
Standard and checking
The opening stroke of the flap clamp 3 must be adjusted in such a way
that the whole length of the flap clamp is pressed against the main
clamp when the flap clamp cylinder 2 is extended.
–
Switch the sewing unit on.
– Close the flap clamp.
– Check whether the flap clamp is pressed against the main clamp
over its whole length.
Correction
–
Loosen the screws 1.
– Shift the cylinder 2 correspondingly.
– Tighten the screws 1.
20
3 2 1