Beisler 100-68 - Manual (Page 25)

6. Function and operation of the optional equipment
This chapter describes the function and operation of the most
important
optional equipment.
6.1 Tape feeding unit with automatic trimming and tape monitor
The step motor- and length-controlled tape feed with automatic
trimming transports the reinforcement strip under the pocket opening
and cuts it off at the seam end (e.g. when sewing inside and outside
pockets of men’s jackets).
A sensor supervising the tape feed is integrated in the tape feeding
unit.
The whole sequence is realized within the machine time
so that there are no further feeding or secondary processing times.
If the tape is not pulled during the sewing process, e.g. in case of
accumulation or wrong threading, a message is produced by the
control.
Activating and switching the tape feed on
–
Activate the tape feed at the control panel in the menu item “Seam
functions”.
– Tap the icon.
1
23