Beisler 100-68 - Manual (Page 125)

6.6.2.3 Testing the centre knife
With this program the centre knife drive can be tested.
– Tap the icon “centre knife test”.
The numeric pad appears.
– Enter the desired speed in % via the numeric keypad (standard =
40 %).
– Tap the icon “OK”.
– Tap the icon “ON”.
The motor runs at the entered speed.
– Tap the icon “cylinder”.
The cylinder presses the knife into the cutting position.
– Tap the icon “OFF”.
The motor stops.
– Tap the function key ESC to quit the test program.
41
4