Beisler 100-68 - Manual (Page 19)

3.2 Reference position
Reference position
The reference position is necessary to reach a defined initial position.
When the sewing unit is switched on, the control checks whether the
transport carriage is in its rear end position.
If this is not the case, the display shows the following message:
Caution: Risk of injury !
Risk of bruises between folder and deposit table.
– Press the program stop switch.
The reference run starts.
The transport carriage moves to its rear end position.
– The display changes over to the main screen of the sewing unit.
3.3 Starting the sewing process
– Actuate the central foot switch.
By actuating the central foot switch repeatedly the different steps
of the feeding process are started one after the other.
The individual steps depend on the working method and on the
equipment of the sewing unit.
– For feeding corrections:
Actuate the right foot switch or press the reset key.
The last step of the feeding process is cancelled.
The workpiece can be fed anew.
– Step the central foot switch to the front.
The sewing process starts.
The individual steps of the feeding process can be cancelled.
1
17