Beisler 100-68 - Manual (Page 53)

3.4 Parallelism of main clamp and sliding sheet
Caution: Danger of injury!
Switch the main switch off.
Check and adjust the transport clamps only with the sewing unit
switched off.
Standard and checking
The main clamp 1 must be in parallel position to the sliding sheet over
its whole length.
–
Move the clamp to the feeding position.
– Place thin fabric under the clamping arms.
– Close the main clamp.
– Pull the fabric out to the side and check for equal distance.
Correction
–
Loosen the counternuts 2.
– Adjust the pressure with the Allen screws 3.
– Tighten the counternuts 2 again.
3
15
1 3 2