Beisler 100-68 - Manual (Page 59)

3.7 Changing the rubber strips of the clamp
Caution: Risk of injury!
Switch the main switch off.
Dismount and mount the main clamp only with the sewing unit switched
off.
Standard and checking
There are sponge rubber strips under the main clamps. In case of
material processing problems the rubber strips should be checked and
replaced, if required.
–
Check the rubber strips.
Correction
–
Unscrew the screws 5.
– Take the clamp off.
– Unscrew the screws 3.
– Exchange the rubber strips 4 and tighten with the screws 3.
– Mount the clamp again.
Note
When processing thick fabrics it is of advantage to equip the clamp
with a thicker rubber strip or to fit an elevation.
21
3
5 2 1 3 4 3