Beisler 100-68 - Manual (Page 27)

Inserting the reinforcement strip
–
Put roll 1 on the tape roll holder 2.
The full roll must rotate in the indicated arrow direction
(counter-clockwise) when unwinding.
– Guide the reinforcement strip via guide 5.
– Swivel the fabric sliding sheet 9 aside.
– Press slide 7 backwards and lift off cover 8.
– Insert the reinforcement strip in the feeding device according to the
sketch.
– Swivel the fabric sliding sheet 9 back again.
– Tap the key.
The reinforcement strip is cut off and moved to the initial position.
Function and operation
Before the next sewing cycle the reinforcement strip is fed forward a
little by the transport roller of the feeding device.
When sewing the pocket opening the reinforcement strip is seized and
sewn in according to the set sewing length.
The tape projection at the seam beginning and seam end can be set in
the menu item “Seam parameters” with the parameters 21 and 22 (see
programming instructions).
1
25