Beisler 100-68 - Manual (Page 80)

12. Adjusting the optional equipment
12.1 Downholder
With the downholder the fullness in the pocket opening area caused by
darts is smoothened and safely held.
Caution: Risk of injury !
Switch the main switch off.
Check and adjust the downholder only with the main switch switched
off.
Standard
The downholder 3 should be aligned in such a way that it lowers
exactly on the drill-hole 5 in the sliding sheet.
It must be aligned in such a way that it is not hit by the opened clamps.
Adjusting the downholder
–
Loosen the screws 2 at the holder 1.
– Adjust the height of the downholder 3.
When the pedal is actuated, the extended piston rod should just
touch the hole in the fabric sliding sheet.
– Align the downholder 3 to the back (in machine head direction).
The piston rod should hold the hind trousers part clamped.
– Tighten the screws 2 on the holder 1.
– Regulate the lowering speed of the downholder 3 with the throttle
valves 4 and 5.
The lowering motion should be rapid, but not abrupt.
42
4 3 2 1
6
5 3