Beisler 100-68 - Manual (Page 79)

3
11. Fabric sliding sheet and vacuum plate
11.1 Adjusting the height of the vacuum plate
Standard and checking
The vacuum plate should be on one level with the table top.
–
Lift the fabric sliding sheets 1 at the front and swivel them to the
left.
– Check the height of the vacuum plate as to the table top.
Caution: Risk of injury!
Switch the main switch off.
Adjust the vacuum plate only with the sewing unit switched off.
The vacuum plate is connected with the table top support by four core
pins 2.
–
Turn the core pins 2.
In clockwise direction
= vacuum plate higher
Counter-clockwise = vacuum plate lower
– Readjust the support screws 3.
41
3 2 1