Beisler 100-68 - Manual (Page 51)

3.2 Parallelism of the transport clamps
Caution: Risk of injury!
Switch the main switch off.
Check and adjust the parallelism of the transport clamps only with the
sewing unit switched off.
standard and checking
The transport clamps 1 and 2 should run parallel to the edge of the
sliding sheet 3.
–
Push the transport carriage to the front.
– Check the distance of the transport clamps to the edge of the
sliding sheet.
Correction
–
Loosen the screws 4 and 6.
– Adjust the transport clamps with the screws 5 so that they are in
parallel position to the edge of the sliding sheet.
– Tighten the screws 4 and 6.
13
3
3 2 1 6 5 4