Guralp Systems CMG-DCM build <10,000 User Manual
Page 176
Acquisition Modules and Platinum Firmware
Transmitting Data
Terminal
Disable terminal access: Used to prevent clients of this server from accessing
the command line of the originating digitiser via the connection, allowing
support for data consumers who should not be allowed to reconfigure the data
sources. If this check-box is ticked, the table below can be used to either
prohibit terminal access to all hosts except those listed (by ticking the
relevant Reject check-boxes) or to allow access to all hosts except those lists
(by leaving the relevant Reject check-boxes clear).
Push
The scream server is capable of both responding to data requests from clients
(PULL mode) and of sending data uninvited to remote destinations (PUSH
mode). The table below is used to list any PUSH mode clients. For each, a
Host must be specified as either an IP address or hostname and a Port must be
given as either a service number or name.
176
Issue E - February 2014