Guralp Systems CMG-DCM build <10,000 User Manual
Page 185
Acquisition Modules and Platinum Firmware
Transmitting Data
You can reconfigure any existing service by clicking on its menu entry. To
configure a new SEEDlink server, select “Create service instance”. The
following screen, shown overleaf, allows you to configure the parameters of
the server.
12.2.2.1 Configurable parameters in simple mode
The configurable parameters for the SEEDlink network server are contained
in a single form in simple mode:
General
User description: Set to a meaningful name for the server data.
Enable: Causes this service to start automatically when the system is
re-booted. If this check-box is cleared, the service will need to be started
manually (from the “Control” → “Services” menu)
Delete: Causes the configuration for this instance to be removed from the
system when the form is submitted.
Server hostname/IP address: To configure the server to listen for incoming
data requests only on a specific IP address, set this (or the associated host
name) in the text field. By default it will listen on all configured interfaces.
Server Port/service name: Set the port (port number or service name) that
you want the server to listen on in the text field.
Organization: The server identifies itself to clients with an organization
name, this should be entered into the text-field. If left blank, the value will
default to “Güralp Systems Ltd”.
185
Issue E - February 2014