Guralp Systems CMG-DCM build <10,000 - Manual (Page 261)

Acquisition Modules and Platinum Firmware Appendices
16 Appendices
16.1 Appendix A - Setting the System Identity (Hostname)
The system identity is pre-set at the factory to contain a device-type identifier
and the system's serial number, such as “EAM2010”. It should not be
necessary to change this but, should you desire to, the following procedure
can be used.
To set the system identity using the web interface select:
Configuration → Hostname
or
Configuration → All options → System identity (hostname)
To set the system identity from the command line, start gconfig and select
“System identity (hostname)” from the top level menu.
The following screen is displayed:
Use this screen to set the hostname of the system.
MAN-EAM-0003 261 Issue E - February 2014