5 quick seismic characteristic data – Guralp Systems CMG-DCM build <10,000 User Manual
Page 196
Acquisition Modules and Platinum Firmware
Transmitting Data
12.5 Quick Seismic Characteristic Data
QSCD is a protocol developed by KIGAM
to send
strong motion results, which are computed every second.
To set up a QSCD server on the acquisition module, first configure the
relevant strong motion data sources as described in section 8.1.1.4 on page
103, then, from the web interface, select:
Configuration → Services → Miscellaneous
or
Configuration → All options → System services → Miscellaneous
To configure a QSCD server from the command line, start gconfig and select
“System services” from the top level menu.
Now select “qscd-out -- KIGAM QSCD (Quick Seismic Characteristic Data)
sender ” from the System Services menu. The next screen shows a list of all
QSCD server instances that have been configured:
You can reconfigure any existing service by clicking on its menu entry. To
configure a new QSCD server, select “Create service instance”. The following
screen allows you to configure the parameters of the server. As it is a large
screen, it is shown here in pieces.
12.5.1 Configurable parameters in simple mode
The configurable parameters for the QSCD server have three tabbed pages in
simple mode: General, Network and Channels.
General
User description: Set to a meaningful name for the data that it will serve.
196
Issue E - February 2014