MacroSystem Bogart SE Ver.2 User manual - Manual (Page 97)

95 Bogart SE 2 user manual
You can set up the audio offset range if your TV set requires
more time for audio than your audio receiver . Simply try out
different values to find the best for your needs .
3.3.3. Start melody
Activate or deactivate the melody that is played when the sy-
stem (Media Manager) starts . You can also define the correc-
tion volume . 0dB is the current volume .
3.4 Connections
Depending on the device used, this is where you decide on
the format for the top SCART connection (TV): Activate either
CVBS+RGB or YC . You can also set up the bottom SCART
connection (Video) . Make sure to choose the right setting to
avoid a monochrome image . If you can‘t see the picture or if
the image is shown incorrectly, the system will return to the
previous mode after 10 seconds .
3.5 Parental Control
There are three options: `Youth protection off´, `Youth protec-
tion active´ and `Lock all functions´ . Use `Safety method´ to
set up the youth protection key . Press the respective number
button to choose `Enter/change Parental Control PIN´, `Use Pa-
rental Control PIN´, `Use dongle´ and `Register/change dongle´ .
At the time of writing this manual, there are only 2 available
options: 1) Fully locking the device once you power down the
system from the Media Manager . Press 2) Options - allowed
media - Archives and Change Settings to lock certain Media
Manager settings . Also: You can lock the front ON/OFF button .
Note: Powering the unit up is then only possible using the
remote control .
3.6 Device
Here, you can set up the `Power Savingr´ mode . Deactivate it
completely (`Never´), so that the device is not powered down
completely . This has the advantage that the unit starts up
faster . You can also set up the display brightness modes for
standby or in use . If you set up both display and power saving
to `immediately´, the Casablanca will go into standby mode
right away when switched off . Please note that some units may
not have a 0-Watts standby operation . This also only works
after a device has been connected to the power line for at least
a day . In 0-Watts use, the display does not show the time . In
addition, you can also reduce the „noise management“ noise
by changing the setting in `DVD/Blu-ray drive´ .