Westermo MRI-128-F4G-PSE24 - Manual (Page 17)

13
3.2 Preparation for Web Interface
The switch provides HTTP Web Interface and Secured HTTPS Web Interface for
web management.
3.2.1 Web Interface
Web management page is developed by JAVA. It allows you to use a standard
web-browser such as Microsoft Internet Explorer, or Mozilla Firefox, to
configure and/or log from the switch from anywhere on the network.
Before you attempt to use the embedded web interface to manage switch
operation, verify that the switch is properly installed on your network and that
every the PC on this network can access the switch via the web browser.
1. Verify that your network interface card (NIC) is operational, and that your
operating system supports TCP/IP protocol.
2. Wire DC power to the switch and connect your switch to your computer.
3. Make sure that the switch default IP address is 192.168.2.200.
4. Change your computer IP address to 192.168.2.2 or other IP address which
is located in the 192.168.2.x (Network Mask: 255.255.255.0) subnet.
5. Switch to DOS command mode and ping 192.168.2.200 to verify a normal
response time.
Launch the web browser and Login.
6. Launch the web browser (Internet Explorer or Mozilla Firefox) on the PC.
7. Type http://192.168.2.200 (or the IP address of the switch). And then press
Enter.
8. The login screen will appear next.
9. Type in the user name and the password. Default user name is admin and
password westermo.
Click on Enter or OK. The welcome page of the web-based management