Westermo MRI-128-F4G-PSE24 User Manual
Page 77
73
“cost” of the path to the other bridge from the transmitting bridge at the
specified port.
Priority: Enter a value between 0 and 240, using multiples of 16. This is the value
that decides which port should be blocked by priority in a LAN.
Admin P2P: Some of the rapid state transitions that are possible within RSTP
depend upon whether the port of concern can only be connected to another
bridge (i.e. it is served by a point-to-point LAN segment), or if it can be connected
to two or more bridges (i.e. it is served by a shared-medium LAN segment). This
function allows P2P status of the link to be manipulated administratively. “Auto”
means to auto select P2P or Share mode. “P2P” means P2P is enabled, while
“Share” means P2P is disabled.
Admin Edge: A port directly connected to the end stations cannot create a
bridging loop in the network. To configure this port as an edge port, set the port
to the Enable state. When the non-bridge device connects an admin edge port,
this port will be in blocking state and turn to forwarding state in 4 seconds.
Once you finish your configuration, click on Apply to save your settings.
4.5.2 RSTP Info