Westermo MRI-128-F4G-PSE24 - Manual (Page 28)

24
4.2 Basic Setting
The Basic Setting group provides you to configure switch information, IP address,
User name/Password of the system. It also allows you to do firmware upgrade,
backup and restore configuration, reload factory default, and reboot the system.
Following commands are included in this chapter:
4.2.1 Switch Setting
4.2.2 Admin Password
4.2.3 IP Configuration
4.2.4 Time Setting
4.2.5 Jumbo Frame
4.2.6 DHCP Server
4.2.7 Backup and Restore
4.2.8 Firmware Upgrade
4.2.9 Factory Default
4.2.10 System Reboot
4.2.11 CLI Commands for Basic Setting
4.2.1 Switch Setting
You can assign System name, Location, Contact and view system information.
System Name: You can assign a name to the switch. The available characters you
can input is 64. After you configure the name, CLI system will select the first 12
characters as the name in CLI system.
System Location: You can specify the switch’s physical location here. The available
characters you can input are 64.
System Contact: You can specify contact people here. You can type the name, mail