Westermo MRI-128-F4G-PSE24 - Manual (Page 22)

18
4 Feature Configuration
This chapter explains how to configure the switch software features. There are
four ways to access the switch: Serial console, Telnet/SSH, Web browser and
SNMP.
Following topics are covered in this chapter: .
4.1 Command Line Interface (CLI) Introduction
4.2 Basic Setting
4.3 Port Configuration
4.4 Power over Ethernet
4.5 Network Redundancy
4.6 VLAN
4.7 Traffic Prioritization
4.8 Multicast Filtering
4.9 SNMP
4.10 Security
4.11 Warning
4.12 Monitor and Diag
4.13 Device Front Panel
4.14 Save
4.15 Logout
4.1 Command Line Interface Introduction
The Command Line Interface (CLI) is one of the user interfaces to the switch’s
embedded software system. You can view the system information, show the
status, configure the switch and receive a response back from the system by
typing in a command.
There are different command modes andeach mode has its own access ability,
available command lines and uses different command lines to enter and exit.
These modes are User EXEC, Privileged EXEC, Global Configuration and
(Port/VLAN) Interface Configuration modes.
User EXEC mode: As long as you log into the switch by CLI you are in the User
EXEC mode. You can ping, telnet remote device, and show some basic
information.
Type enable to enter the next mode, exit to logout. ? to see the command list