Westermo MRI-128-F4G-PSE24 - Manual (Page 55)

51
manufacturers may use different descriptions for their products, like Link
Aggregation Group (LAG), Link Aggregation Control Protocol, Ethernet Trunk,
Ether Channel…etc. Most of the implementations now conform to IEEE standard,
802.3ad.
The aggregated ports can interconnect to the other switch which also supports
Port Trunking. Westermo Supports 2 types of port trunking. One is Static Trunk,
the other is 802.3ad. When the other end uses 802.3ad LACP, you should assign
802.3ad LACP to the trunk. When the other end uses non-802.3ad, you can then
use Static Trunk.
There are two configuration pages, Aggregation Setting and Aggregation Status.
Aggregation Setting
Trunk Size: The switch can support up to 8 trunk groups and. eEach trunk group
can support up to 8 member ports. Since the member ports should use same
speed/duplex, max groups for 100M ports would be 7 groups, and 3 groups for
gigabit ports.
Group ID: Group ID is the ID for the port trunking group. Ports with same group
ID are in the same group.
Trunk Type: Static and 802.3ad LACP. Each Trunk Group can only support Static or
802.3ad LACP. Choose the type you need here.
Load Balance Type: There is several load balance types based on dst-ip
(Destination IP), dst-mac (Destination MAC), src-dst-ip (Source and Destination IP),
src-dst-mac (Source and Destination MAC), src-ip (Source IP), src-mac (Source
MAC).