Yaskawa Z1000U - Manual (Page 96)

u LCD Display
2 1 3
9 8 7
6
5
4 Freq Ref
Figure 4.2 LCD Display
Table 4.1 Display and Contents
No. Name Display Content
1 Operation Mode Menus
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
2 Mode Display Area
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
3 Ready Rdy Indicates the drive is ready to run.
4 Data Display — Displays specific data and operation data.
5
Frequency
Reference
Assignment <1>
OPR Displayed when the frequency reference is assigned to the HOA keypad.
AI Displayed when the frequency reference is assigned to the Analog Input of the drive.
COM
Displayed when the frequency reference is assigned to the MEMOBUS/Modbus Communication
Inputs of the drive.
OP Displayed when the frequency reference is assigned to an option card connected to the drive.
6
LO/RE
Display <2>
RSEQ Displayed when the run command is supplied from a remote source.
LSEQ Displayed when the run command is supplied from the operator keypad.
RREF Displayed when the frequency reference is supplied from a remote source.
LREF Displayed when the frequency reference is supplied from the operator keypad.
7
Function Key 1
(F1)
JOG
Pressing F1 runs the motor at the Jog frequency.
HELP
Pressing F1 displays the Help menu.
←
Pressing F1 scrolls the cursor to the left.
HOME
Pressing F1 returns to the top menu (Frequency Reference).
ESC
Pressing F1 returns to the previous display.
8 FWD/REV
FWD Indicates forward motor operation.
REV Indicates reverse motor operation.
4.2 Using the HOA Keypad
96 YASKAWA ELECTRIC TOEP C710636 10B Z1000U HVAC MATRIX Drive User Manual