Yaskawa Sigma-5 User Manual: Setup for Linear Motors - Manual (Page 120)

3 Wiring and Connection
3.3.7 Wiring the Spring Type Main Circuit Terminal Connector
3-36
3.3.7 Wiring the Spring Type Main Circuit Terminal Connector
Two types of main circuit terminals are available: a connector type and a terminal
screw type.
• SERVOPACKs with terminal screws:
SGDV-180A, 200A, 330A, 550A, 8R4D, 120D, 170D, 260D
• SERVOPACKs with connectors:
SGDV-R70F, R90F, 2R1F, 2R8F, R70A, R90A, 1R6A, 2R8A, 3R8A, 5R5A, 7R6A, 120A,
1R9D, 3R5D, 5R4D
A spring connector is used for SERVOPACKs with connectors.
The following section describes how to wire the main circuit terminal using a con-
nector.
 Wiring Procedure
1.
Remove the main circuit terminal connector from the SERVOPACK.
CAUTION
• Observe the following precautions when wiring main circuit terminal connectors.
• For the SERVOPACKs with connectors, remove detachable main circuit terminal con-
nectors from the SERVOPACK prior to wiring.
• Insert only one main circuit cable per opening in the main circuit terminal connector.
• Make sure that no part of the core wire comes into contact with (i.e., short-circuit)
adjacent wires.
Main circuit
terminal connector
Enlarged View
Lock
1㧚Press
the lock.
2. Remove the main
circuit terminal
connector while
pressing the lock.