Yaskawa Sigma-5 User Manual: Setup for Linear Motors - Manual (Page 83)

2.5 EMC Installation Conditions
2-61
2
Installation
 Three-phase 400 V, SGDV-260D25A
∗1. Products that have received CE marking are recommended for the 24 VDC power supply.
∗2. Install the following noise filter on the power line between the single-phase 200 V power
supply and the 24 VDC power supply.
Model number: FN2070-6/07 (SCHAFFNER)
∗3. For more information on this filter, refer to Σ -V Series Product Catalog (No.: KAEP
S800000 42).
Symbol Cable Name Specification
 I/O signal cable Shield cable
 Cable for safety unit Shield cable
 Linear servomotor main circuit cable Shield cable
 Linear scale connection cables Shield cable
 Control power cable Shield cable
 Main circuit cable Shield cable
 Regenerative resistor unit cable Non-shield cable
 MECHATROLINK-III communication cable Shield cable
CN2
1 2
3
6
5
8
7
4
U, V, W
L1, L2, L3
B1, B2
24 V,
0 V
CN1
PE
PE
CN8
CN6A, CN6B
MECHATROLINK-III
controller
SERVOPACK
Safety unit
Linear
scale
Linear
servomotor
Power supply:
Single-phase
200 VAC
Power supply:
Three-phase
400 VAC
Shield box
Clamp Clamp
Clamp
Clamp
Clamp
Noise
filter* 3
Regenerative
resistor unit
Surge
absorber
Surge
absorber
Surge
absorber
Noise
filter* 2
Control
power
supply
24 VDC* 1
Clamp
Clamp Clamp
Host controller