Yaskawa Sigma-5 User Manual: Setup for Linear Motors - Manual (Page 96)

3 Wiring and Connection
3.2.3 Connecting to SGDV-25 SERVOPACK (M-III Model)
3-12
3.2.3 Connecting to SGDV-  25  SERVOPACK (M-III Model)
(1) SGDV-F25A
∗1. Before connecting an external regenerative resistor to the SERVOPACK, refer to 3.4 Con-
necting Regenerative Resistors.
∗2. The connected device and cable depend on the model of the linear scale.
R T
Regenerative
resistor* 1
Noise filter
Molded-case
circuit breaker
(MCCB)
Magnetic contacator
I/O signal cable
SGDV- F25A
SERVOPACK
Power supply
Single-phase 100 VAC
Protects the power supply
line by shutting the circuit
OFF when overcurrent
is detected.
Used to eliminate
external noise from
the power line.
Turns the servo
ON and OFF.
Install a surge
absorber.
Personal
computer
Connection cable
for personal computer
Digital
operator
When not using the safety
function, use the SERVOPACK
with the safety function jumper
connector (JZSP-CVH05-E,
provided as an accessory)
inserted.
When using the safety function,
insert a connection cable
specially for the safety function.
Safety function
devices
Connection cable
for digital operator
Host controller
Connect to the
MECHATROLINK-III
Linear servomotor
main circuit cable
Serial converter unit * 2
Cable for connecting a
serial converter unit * 2
Linear servomotor
with core
Linear scale
(Not included)
Cable for connecting a
hall sensor
Cable for connecting a
linear scale * 2