RIGOL MSO/DS2000A Series - Manual (Page 200)

RIGOL Chapter 9 Reference Waveform
9-2 MSO2000A/DS2000A User’s Guide
To Enable REF Function
Press REF in the vertical control area (VERTICAL) at the front panel to enable the
REF function.
Note: When the time base is in X-Y mode, REF function cannot be enabled.
MSO2000A/DS2000A provides 10 reference waveform channels. Press Channel,
rotate
to select the desired reference channel and press down or Channel
to turn the selected channel on or off. A channel icon (for example, ) of the
channel enabled will be displayed at the left side of the screen grid.
When the REF function is enabled, you can select different color for each reference
waveform, set the source of each reference channel, adjust the vertical scale and
position of the reference waveform and save the reference waveform to internal or
external memory as well as recall it when needed. For the details, please refer to the
introductions below.
To Set the Color
MSO2000A/DS2000A series oscilloscope provides five colors (gray, green, light blue,
magenta and orange) to mark the reference waveforms of different channels in order
to distinguish them.
Press Current and use
to select any of the reference channels (Ref1-Ref10)
enabled. Then, press Color to specify a different color for the reference waveform of
that channel. The corresponding icon at the left of the channel currently selected will
be filled with the specified color, for example,
.
To Select REF Source
Press Current and use
to select any of the reference channels (Ref1 to Ref10)
enabled and then press Source to specify a reference source (CH1, CH2, MATH or
any channel of D0-D15) for this channel. Only the channels currently enabled can be
selected.