RIGOL MSO/DS2000A Series - Manual (Page 288)

RIGOL Chapter 16 Remote Control
MSO2000A/DS2000A User’s Guide 16-2
Remote Control via USB
1. Connect the device
Connect the oscilloscope (USB DEVICE) with your PC using a USB cable.
2. Install the USB driver
This oscilloscope is a USB-TMC device. Assuming that your PC has already been
installed with Ultra Sigma, after you connect the oscilloscope to the PC and turn
both on for the first time (the oscilloscope is automatically configured to USB
interface), the New Hardware Wizard as shown in the figure below is
displayed on the PC. Please install the “USB Test and Measurement Device (IVI)”
driver following the directions in the wizard. The steps are as follows.
1
2