RIGOL MSO/DS2000A Series - Manual (Page 305)

Chapter 18 Specifications RIGOL
MSO2000A/DS2000A User’s Guide 18-7
Data Bits 4 bit to 32 bit
Data Line
Setting H, L, X
CAN Trigger (Option)
Signal Type
Rx, Tx, CAN_H, CAN_L, Differential
Trigger
Condition SOF, EOF, FrameType, FrameError
Signal Rate 10 kbps, 20 kbps, 33.3 kbps, 50 kbps, 62.5 kbps, 83.3 kbps, 100
kbps, 125 kbps, 250 kbps, 500 kbps, 800 kbps, 1 Mbps, User
Sample Points 5% to 95%
Frame Type
Data, Remote, Error, OverLoad
Error Type Bit Fill, AnswerError, CheckError, FormatError, RandomError
USB Trigger (Option)
Signal Speed
Low Speed, Full Speed
Trigger
condition SOP, EOP, RC, Suspend, Exit Suspend
Measure
Cursor
Manual Mode
Voltage Deviation between Cursors (△V)
Time Deviation between Cursors (△T)
Reciprocal of △T (Hz) (1/△T)
Track Mode Voltage and Time Values of the Waveform
Point
Auto Mode Allow to display cursors during auto
measurement
Auto
Measurement Analog channel:
Maximum, Minimum, Peak-Peak Value, Top Value, Bottom Value,
Amplitude, Average, Mean Square Root on Whole Signal, Mean
Squrare Root on Single Period, Overshoot, Pre-shoot, Area, Period
Area, Frequency, Period, Rise Time, Fall Time, Positive Pulse
Width, Negative Pulse Width, Positive Duty Cycle, Negative Duty
Cycle, Delay 1 2 , Delay 1 2 , Delay 1 2 , Delay
1 2 , Phase 1 2 , Phase 1 2 , Phase 1 2 , Phase
1 2
Digital channel: