Kyocera Command Center RX - Manual (Page 102)

Management Settings
98 Embedded Web Server
FAX / i-FAX
From the drop-down list, select Off, On, Error Only, or Specify Each Job. If an
error occurs during transmission, Error Only allows printing a transmission result.
Attach Image
Select either Off, Partial Image, or Full Image.
Canceled before Sending
Select either On or Off.
Recipient Format
Select either Name or Destination or Name and Destination.
4.
You can configure settings for Receive Result Report.
FAX/i-FAX RX
From the drop-down list, select Off, On, or Error/Storing in Box. If an error occurs
during reception or received draft is forwarded to fax box, Error/Storing in Box
allows a receive result reported by e-mail or report.
Report Type
Select either Print Report or E-mail.
E-mail Address
Enter the e-mail address if you select E-mail as a report type.
5.
You can configure settings for Job Finish Notice.
Attach Image
Select either On or Off.
6.
You can configure settings for Maintenance Report.
Equipment ID
Enter the equipment ID.
Recipient E-mail Address
Enter the E-mail address to receive the maintenance reports. Use a semicolon (;)
between multiple addresses.
Subject
Enter the Subject of the report.
Maintenance Report Interval
From the drop-down list, select one of None, Monthly, Weekly, Daily, Hourly as
desired.
For Monthly, check the month and select a date and a time from the Day and Time
drop-down lists, respectively.
For Weekly, select a day of the week and a time from the Day and Time drop-down
lists, respectively.