Kyocera Command Center RX - Manual (Page 106)

Management Settings
102 Embedded Web Server
SNMP
This section includes advanced settings for SNMP.
If the settings for the item marked with an asterisk (*) has been changed, you must
restart the machine or the network. To restart the machine, proceed to the Reset page.
SNMP Settings
1.
Click SNMP under Management Settings on the navigation menu. The SNMP
Settings page opens.
2.
Configure SNMPv1/v2c as follows.
SNMPv1/v2c
Activate or deactivate the SNMPv1/v2c protocol. Select either On or Off in the Pro-
tocol Settings page under Network Settings. To configure SNMP v1/v2, proceed
as follows.
Read Community
Enter the community name for SNMP requests to read a value. The default name is
'public'. After you have changed the setting, you must restart the printing system.
Write Community
Enter the community name for SNMP requests to write (change) a value. The
default name is 'public'. After you have changed the setting, you must restart the
printing system.
sysContact
The MIB-II sysContact object. Usually this is the E-mail address of the network
administrator.
sysName
The MIB-II sysName object. Usually this is the host or domain name of the printing
system.
sysLocation
The MIB-II sysLocation object. Usually this is the location information of the printing
system which is described under Location of System Settings page. Go to the
System Settings page under Device Settings to modify the settings.
HP Web Jetadmin Compatibility
Turns HP Web Jetadmin Compatibility On or Off. After you have changed the set-
ting, you must restart the printing system.
Authentication Traps
Specifies whether to use authentication traps. If enabled (On), an SNMP trap is
generated when an attempt to read or write is made using an incorrect community
name. The trap is sent to the configured trap address. After you have changed the
setting, you must restart the printing system.