Kyocera Command Center RX - Manual (Page 87)

Security Settings
User Guide 83
Document Guard Settings
This setting appears when an optional Printed Document Guard Kit(B) is activated.
Select On to use the Document Guard.
3.
Click Submit button.
Send Security
This section includes settings for security for Sending.
1.
Click Send Security under Security Settings on the navigation menu. The Send
Security Settings page opens.
2.
This section includes the following items for configuration.
Dest. Check before Send
This enables the front panel message which prompts you to confirm the destination
to forward the scan data. To enable, select On. The message is displayed when the
machine's Start key is pressed to start scanning.
Entry Check for New Dest.
When enabled, this determines whether re-entry of a destination for confirmation is
required when adding a new destination. To enable, select On.
New Destination Entry
Determines whether an entry of a new destination is allowed. Permit activates the
entry of a new destination. Prohibit deactivates the entry of a new destination.
New Destination Entry (FAX)
This entry becomes active when New Destination Entry has been set to Permit.
Permit activates the entry of a new fax destination. Prohibit deactivates the entry
of a new fax destination.
Recall Destination
Enables or disables recalling the destination. Permit activates the entry of a desti-
nation to recall. Prohibit deactivates the entry of a destination to recall.
Broadcast
Enables or disables broadcast transmission. Permit activates the broadcast trans-
mission. Prohibit deactivates the broadcast transmission.
3.
Click Submit button.
Network Security
This section includes settings for network security.
*: If the settings for the item marked with an asterisk (*) has been changed, you must
restart the machine or the network. To restart the machine, proceed to the Reset page.