Kyocera Command Center RX - Manual (Page 75)

Network Settings
User Guide 71
Lifetime (Time): Configure the lifetime of IPSec SA in seconds.
Lifetime (Data Size): Configure this item when is Time & Data Size selected as
Lifetime Measurement. Configure the lifetime (data size) of IPSec SA in kilo-
bytes.
Extended Sequence Number: Determines whether a sequence number is 64-bit
extended by IPSec. To execute, select On.
6. Manual: If Key Management Type is set to Manual, configure:
Protocol, Hash, Encryption, SPI Format, SPI for Inbound, SPI for Outbound,
Key Format, Authentication Key for Inbound, Authentication Key for Out-
bound, Encryption Key for Inbound, Encryption Key for Outbound.
Click Submit button to finalize settings.
3.
Click Submit button.
Protocol
This section includes advanced settings for various protocols used as the
communication procedures and communication protocols.
*: If the settings for the item marked with an asterisk (*) has been changed, you must
restart the machine or the network. To restart the machine, proceed to the Reset page.
1.
Click Protocol under Network Settings on the navigation menu. The Protocol
Settings page opens.
2.
This section includes the following items for configuration.
Print Protocols
Configure the protocols used for printing. This section includes the following items
for configuration:
1. NetBEUI: The NetBEUI protocol allows Peer-to-peer printing (SMB Print). With
this protocol enabled, the printing system is created in Windows Network
Neighborhood. NetBEUI is an enhanced version of the NetBIOS protocol, which is
used for transport of SMB protocol.
Enables or disables the NetBEUI protocol. If NetBEUI is turned On, the name res-
olution by NetBIOS (NMB) becomes available.
Available Network: Select Wired Network, Wi-Fi and Wi-Fi Direct as the avail-
able network for NetBEUI protocol.
Workgroup: Workgroup represents the workgroup which will appear in Entire
Network in "Windows Network Neighborhood."
Comment: You can enter comments here. (This can be left blank.)
2. LPD: To enables the LDAP protocol, turn this item On.
Available Network: Select Wired Network, Wi-Fi and Wi-Fi Direct as the avail-
able network for LPD protocol.
3. FTP Server (Reception): FTP is a communications protocol for transmitting files
over a Network. To enables the FTP protocol, turn this item On.
Available Network: Select Wired Network, Wi-Fi and Wi-Fi Direct as the avail-
able network for FTP protocol.
4. IPP: IPP is a protocol which performs transmission and reception of printing data
and configuration of printing systems through TCP/IP networks including the
Internet. To enables the IPP protocol, turn this item On.
Available Network: Select Wired Network, Wi-Fi and Wi-Fi Direct as the avail-
able network for IPP protocol.
Port Number: Enter the port number. Typically, this should be 631.(e.g. http://(IP
address):631/printers/lp1)