NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 241)

Table 60. VLAN Status (Continued)
Definition Field
The type of the VLAN you selected:
• Default (VLAN ID = 1): Always present.
• Static: A VLAN that you added manually.
• Dynamic: A VLAN that was created through GVRP registration and that you did
not convert to static, and that GVRP can therefore remove.
VLAN Type
The interface associated with the VLAN, if VLAN routing is configured for this VLAN. Routing Interface
The interfaces and LAGs that are members of the VLAN. Member Ports
Change the port VLAN ID settings
By default, each interface is assigned a port VLAN ID (PVID) of 1 because it is associated
with the default VLAN, VLAN ID 1.
If you want to change the PVID for an interface, the interface must be a member of at
least one other VLAN in addition to the default VLAN.
In addition to the PVID, you can configure other PVID-related settings.
To configure the PVID and PVID-related settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > VLAN > Advanced > Port PVID Configuration.
The Port PVID Configuration page displays.
6. Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
• 1 or Unit ID for a stacked switch:
Main User Manual 241 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual