NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 616)

c. Specify a policy action for packets that exceed the two-rate policy.
- Send: Packets are forwarded unmodified. This is the default violating
action.
- Drop: Packets are dropped.
- Mark CoS: Packets are marked by DiffServ with the specified CoS value
before being forwarded. This selection requires that the Mark CoS field is
set. You must select a CoS value from 0 to 7 from the menu.
- Mark IP Precedence: These packets are marked by DiffServ with the
specified IP Precedence value before being forwarded. This selection
requires that the Mark IP Precedence field is set. You must select an IP
precedence value from 0 to 7 from the menu.
- Mark IP DSCP: Packets are marked by DiffServ with the specified DSCP
value before being forwarded. This selection requires that the DSCP field
is set. You must either select a DSCP code from the menu or enter an IP
DSCP value from 0 to 63 in the field next to the menu. A value that you
enter in the field overrides any selection from the menu.
The DSCP value is defined as the high-order six bits of the Service Type
octet in the IP header.
d. Specify a policy action for packets that violate the two-rate policy.
- Send: Packets are forwarded unmodified. This is the default violating
action.
- Drop: Packets are dropped.
- Mark CoS: Packets are marked by DiffServ with the specified CoS value
before being forwarded. This selection requires that the Mark CoS field is
set. You must select a CoS value from 0 to 7 from the menu.
- Mark IP Precedence: These packets are marked by DiffServ with the
specified IP Precedence value before being forwarded. This selection
requires that the Mark IP Precedence field is set. You must select an IP
precedence value from 0 to 7 from the menu.
- Mark IP DSCP: Packets are marked by DiffServ with the specified DSCP
value before being forwarded. This selection requires that the DSCP field
is set. You must either select a DSCP code from the menu or enter an IP
DSCP value from 0 to 63 in the field next to the menu. A value that you
enter in the field overrides any selection from the menu.
The DSCP value is defined as the high-order six bits of the Service Type
octet in the IP header.
12. Click the Apply button.
Your settings are saved.
13. To save the settings to the running configuration, click the Save icon.
Main User Manual 616 Configure Quality of Service
Fully Managed Switches M4350 Series Main User Manual