NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 592)

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select QoS > CoS > Advanced > Interface Queue Configuration.
The Interface Queue Configuration page displays.
6. Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
• 1 or Unit ID for a stacked switch:
- 1: If no switch stack is configured, the physical interfaces for the switch are
displayed.
- Unit ID for a stacked switch: If a switch stack is configured, the physical
interfaces for the switch with the selected stack unit ID are displayed.
• LAG: Only LAGs are displayed.
• All: Both physical interfaces and LAGs are displayed, or for a switch stack, both
physical interfaces on all switches in the stack and LAGs are displayed.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or
type the port number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
8. From the Queue ID menu, select the queue.
You can select a queue from 0 to 6. (For CoS, queue 7 is reserved for stacking.)
9. In the Minimum Bandwidth field, specify the minimum guaranteed bandwidth
allotted to the queue on the interface.
Setting this value higher than its corresponding maximum bandwidth automatically
increases the maximum to the same value. The default value is 0. The range is from
0 to 100 in increments of 1. The value 0 means that no guaranteed minimum
bandwidth is applied. The sum of the individual minimum bandwidth values for all
queues on the selected interface cannot exceed the maximum (100).
The setting applies only to the queue that you select from the Queue ID menu.
10. From the Scheduler Type menu, select the type of scheduling that is used for the
queue on the interface:
Main User Manual 592 Configure Quality of Service
Fully Managed Switches M4350 Series Main User Manual