NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 818)

select Other and a field displays in which you can enter numeric value of the
DSCP.
- IP Precedence: This is an optional configuration. The IP precedence field in
a packet is defined as the high-order three bits of the service type octet in the
IP header. Enter an integer from 0 to 7.
- IP TOS: This is an optional configuration. The IP ToS field in a packet is defined
as all 8 bits of the service type octet in the IP header. The ToS bits value is a
hexadecimal number from 00 to 09 and to aa to ff. The ToS mask value is a
hexadecimal number from 00 to FF. The ToS mask denotes the bit positions
in the ToS bits value that are used for comparison against the IP ToS field in
a packet.
For example, to check for an IP ToS value for which bit 7 is set and is the most
significant value, for which bit 5 is set, and for which bit 1 is cleared, use a ToS
bits value of 0xA0 and a ToS mask of 0xFF.
• Rate Limit Conform Data Rate: Specify the value of the conforming data rate,
which is the data rate at which confirming traffic is limited. The range is from 1
to 4294967295 Kbps.
• Rate Limit Burst Size: Specify the value of the burst size, which is the size at
which bursts of traffic above the confirming data rate are permitted. The range
is from 1 to 128 Kbps.
• Time Range: From the Time Range menu, select the timer schedule that must
be associated with the rule. For more information about timer schedules, see
Timer schedules on page 180. If you did not set up any timer schedules, the menu
does not present any options.
9. Click the Apply button.
Your settings are saved.
The Rule Status field in the table shows if the rule is active or inactive. Blank means
that no timer schedule is associated with the rule.
10. To save the settings to the running configuration, click the Save icon.
Modify the match criteria for an extended IPv4 ACL
rule
You can modify the match criteria for an extended IPv4 ACL rule.
To modify the match criteria for an existing extended IPv4 ACL rule:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
Main User Manual 818 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual