NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 826)

- If you select the IPv6 Address radio button, enter an IPv6 address to apply
this criteria. If this field is left empty, it means any.
- If you select the Host radio button, enter a host source IPv6 address to match
the specified IPv6 address. If this field is left empty, it means any.
The source IPv6 address argument must be in the form documented in RFC 2373
where the address is specified in hexadecimal numbers using 16-bit values
between colons.
• Dst L4: The options are available only if the selection from the Protocol Type
menu is TCP or UDP. Use the destination L4 port option to specify relevant
matching conditions for L4 port numbers in the IPv6 ACL rule.
You can either enter the port number yourself or select one of the following
protocols from the menu:
- The destination IP TCP port protocols are Domain, Echo, FTP, FTP data,
www-http, SMTP, Telnet, POP2, POP3, and BGP.
- The destination IP UDP port protocols are Domain, Echo, SNMP, NTP, RIP,
Time, Who, and TFTP.
Each of these values translates into its equivalent port number, which is used as
both the start and end of the port range.
Select Other from the menu to enter a port number. If you select Other from the
menu but leave the field blank, it means any.
The only relevant matching condition for L4 port numbers is equal. This means
that an IPv6 ACL rule matches only if the Layer 4 destination port number is equal
to the specified port number or port protocol.
• ICMPv6: The Type and Message fields are enabled only if the protocol is ICMPv6.
Use these fields to specify a match condition for ICMPv6 packets. Select either
the Type or Message radio button:
- If you select the Type radio button, note the following:
The Type and Code fields are enabled only if the protocol is ICMPv6. Use
these fields to specify a match condition for ICMPv6 packets: -
- If you specify information in the Type field, the IPv6 ACL rule matches the
specified ICMPv6 message type. The type number can be from 0 to 255.
- If you specify information in the Code field, the IPv6 ACL rule matches the
specified ICMPv6 message code. The code can be from 0 to 255.
- If these fields are left empty, it means any.
- If you select the Message radio button, note the following:
- Select the type of the ICMPv6 message to match with the selected IPv6
ACL rule. Specifying a type of message implies that both the ICMPv6 type
Main User Manual 826 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual