NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 405)

13. From the Forward Net Directed Broadcasts menu, select Enable or Disable to
enable or disable the forwarding of network-directed broadcast packets.
The default is Disable, which means that network-directed broadcast packets are
not forwarded but dropped.
14. From the Encapsulation Type menu, select the link layer encapsulation type for
packets transmitted from the specified interface.
You can select Ethernet or SNAP, which is Subnetwork Access Protocol. The default
is Ethernet.
15. From the Proxy Arp menu, select Enable or Disable to enable or disable the proxy
ARP for the interface.
The default is Enable.
16. From the Local Proxy Arp menu, select Enable or Disable to enable or disable the
local proxy ARP for the interface.
The default is Disable.
17. In the Bandwidth (kbps) field, specify the bandwidth for the interface.
This information in this field determines the speed of the interface to higher level
protocols. Some protocols use bandwidth to compute the link cost. The range is
from 1 to 10000000.
18. Form the ICMP Destination Unreachables menu, select Enable or Disable to enable
or disable the interface from sending ICMP destination unreachables messages.
The default is Enable.
19. From the ICMP Redirects menu, select Enable or Disable to enable or disable the
ICMP redirecting mode.
The interface sends an ICMP redirect message only if this function is enabled both
globally and on the interface. The default is Enable.
20. In the IP MTU field, specify the maximum size of IP packets that are sent on the
interface.
The IP MTU is the maximum frame size minus the length of the Layer 2 header. The
range is from 68 bytes to the MTU size that is supported by the interface link. The
default is 1500. A value of 0 indicates that the IP MTU is not configured, in which
case the interface uses the MTU size that is supported by the interface link.
21. Click the Apply button.
Your settings are saved.
22. To save the settings to the running configuration, click the Save icon.
The following table describes the view-only fields on the page.
Main User Manual 405 Manage Routing
Fully Managed Switches M4350 Series Main User Manual