Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 1095)

Fabric OS Command Reference 1065
53-1003131-01
snmpConfig
2
For two traps under the SW-TRAP category, the swEventTrap and the
swFabricWatchTrap, this command provides the option to specify a severity levels
to control the number of generated alerts. When a severity level is configured,
traps below the specified severity level specified are not sent. Refer to the
Examples section for an illustration. Specify one of the following values:
0
None (default)
1
Critical
2
Error
3
Warning
4
Informational
-mib_name mib_name
Specifies the name of the MIB to be configured. This operand is required if you
want to configure MIB traps noninteractively. Valid MIB names include the
following.
• FE-MIB
• SW-MIB
• FA-MIB
•
FICON-MIB
• HA-MIB
• FCIP-MIB
•
ISCSI-MIB
•
IF-MIB
• BD-MIB
• MAPS-MIB
•
T11-FC-ZONE-SERVER-MIB
-bitmask bit_mask
Specifies the bit mask for the MIB. Refer to the table above for valid values.
--enable mibCapability -mib_name mib_name
Enables the specified MIB noninteractively.
--disable mibCapability -mib_name mib_name
Disables the specified MIB noninteractively. When used with the trap name
operand, only the specified trap is disabled.
-trap_name trap_name
Specifies the name of the trap to be enabled or disable. This operand is optional.
Use snmpConfig --show mibCapability for a listing of valid traps.
System Group Configuration Parameters
sysDescr
The system description. The default value is Fibre Channel switch.
sysLocation
The location of the system (switch). The default value is End User Premise. The
string must be at least 4 characters in length; the maximum length is 255
characters.