Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual
Page 843
Fabric OS Command Reference
813
53-1003131-01
portCmd
2
create
Creates a WAN test session. This command supports following options:
-s src_ip
Specifies the local IP address to use for sourcing the probe packets. IPv6
addresses are supported.
-d dst_ip
Specifies the destination IP address to which to probe the IP router path. IPv6
addresses are supported.
-r rate
Specifies the test rate in kbps.
-t time
Specifies the test time in seconds.
i ip-sec_policy
Specifies the policy name for an ipsec configuration.
-b
Specifies the test session is running on bi-directional traffic. By default, the
WAN test session is configured for uni-directional traffic.
modify
Modifies an established WAN test session. This command supports following
options:
-r rate
Specifies the test rate in kbps.
-t time
Specifies the test time in seconds.
-b
Specifies the test session is running on bi-directional traffic. By default, the
WAN test session is configured for uni-directional traffic.
-c
Clears the statistics associated with the WAN test.
show
Displays the WAN test session statistics. This command supports following
options:
-a
Displays statistics for all configured WAN test sessions.
-c
Displays statistics for established WAN test sessions.
-p
Displays statistics for past WAN test sessions.
start
Starts the WAN test session associated with the test ID. This command supports
following option:
-t
Specifies the test time in seconds. Use this option if the test time is not
configured with create or modify options.
stop
Stops the WAN test session associated with the test ID. Use all to stop all WAN
test sessions.