Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 928)

898 Fabric OS Command Reference
53-1003131-01
portShow
2
-s | --summary
Displays a summary view of the tunnel configuration parameters for a specific
VE_Port. You can use the summary option with the -perf and the - qos option.
When used with the -perf option, the summary option forces the --circuit option.
Flags indicate ipsec-configured tunnels, legacy ipsec tunnels, and compression
mode. Circuit flags indicate vlan tagging, crossport configuration, and ipv4 or ipv6
configuration.
-d | --detail
Displays a full view configuration details for all configured tunnels when used with
the all port specifier. This view provides an alternative to specifying a specific
VE_Port or to using the --perf option for a comprehensive view.
-I | --ip-address
Displays the IP addresses configured the specified circuits. You must use this
option with either the --summary or the --circuit option. This option is deprecated
but still recognized. Use the -C | --config option instead.
fcipcircuit
Displays FCIP circuit configuration and status. The following operands are
supported with portShow fcipcircuit:
circuit_ID
Specifies a single circuit within the FCIP tunnel. The circuit ID is an integer value
between 1 and 19 on the Brocade FX8-24 and 1 and 7 on the Brocade 7800. This
operand is required.
-t | --tcp
Displays the TCP statistics for the specified circuit.
--reset
Displays time based set of statistics.
--lifetime
Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the
associated TCP connections. This option will ignore any time based deltas
that were created previously set using the --reset option.
-p | --perf
Displays additional performance information for the specified FCIP circuit.
--lifetime
Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the
associated TCP connections. This option will ignore any time based deltas
that were created previously set using the --reset option.
-q | --qos
Displays the QoS statistics including performance for each priority. This operand
is optional with the --perf option.
-C | --config
Displays only the configuration information
mgmtif
Displays the inband management interfaces configured for a specified GbE Port
or for all GbE Ports. For each GbE Port, the display includes the interface status
(enabled or disabled), the interface IPv4 Address, the netmask, effective MTU,
and annotated port flags.
mgmtroute
Displays the management routes configured for a specified GbE Port or for all
GbE Ports. For each GbE Port, the display includes the destination IPv4 Address,
the netmask, the gateway address, and annotated port flags. The metric field is
not valid for the Brocade 7800.