Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual
Page 610
580
Fabric OS Command Reference
53-1003131-01
mapsConfig
2
--emailcfg
Specifies the configuration for e-mail notifications, if email is a triggered action.
You can configure a relay host IP address using the relayConfig command.
-address email_address
Specifies the e-mail address to which the notifications are sent. You can configure
up to 5 e-mail addresses as the alert message's receiver. Multiple e-mail
addresses must be separated by a comma and each e-mail address can be up to
a maximum length of 128 bytes. The e-mail address must conform to standard
syntax: [email protected]. Invalid e-mail addresses are rejected.
--testmail
Sends the test e-mail with the default subject and message along with the switch
name in the message. The command fails if the e-mail address is not configured.
-subject subject
Specifies the user-defined subject line for the test e-mail. This operand is optional.
-message msg
Specifies the user-defined message for the test e-mail. This operand is optional.
--import
Imports a flow from Flow Vision into MAPS.
flow_name
Specifies the name of a flow to be imported. The flow name must be defined in
Flow Vision. This operand is required.
-force
Imports a flow with the same name as the previously imported flow. This operand
is optional. When a flow that was imported into MAPS is deleted in Flow Vision, all
members of the group corresponding to that flow are automatically deleted from
MAPS. If the same flow is created again, it will not automatically be reimported
into MAPS, and importing this flow using the --import option fails unless you use
the -force option.
--deimport
Removes a flow from MAPS. The following operand is required:
flow_name [-force]
Specifies the name of the flow to be removed from MAPS. The -force operand is
optional. You cannot remove a flow that is used by any rules. The -force option
overrides the default behavior. If a flow is present in user-defined rules, the -force
option deletes all the rules that are configured with the given flow and then
removes the flow.
--purge
Deletes all user-defined MAPS configurations on the switch (groups, rules, and
policies). This command does not delete the predefined groups and policies.
Enables dflt_conservative_policy after successful purge.
--enableFPImon
Enables the Fabric Performance Impact Monitoring.
--disableFPImon
Disables the Fabric Performance Impact Monitoring.
--show
Displays the MAPS global configuration settings.
--help
Displays the command usage.