Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual
Page 588
558
Fabric OS Command Reference
53-1003131-01
linkCost
2
1/7 500
1/8 500
1/9 (E_PORT) 500
1/10 500
1/11 500
1/12 500
1/13 500
1/14 500
1/15 500
Type <CR> to continue, Q<CR> to stop:
To set the ISL cost on a port:
switch:admin> linkcost 1/9 1000
To display the new cost value on the same port:
switch:admin> linkcost 1/9
Interface1/9 (E_PORT) Cost 1000 (STATIC)
To delete the cost value and reset to default:
switch:admin> linkcost 1/9 0
To display the change:
switch:admin> linkcost 1/9
Interface1/9 (E_PORT) Cost 500
To set the ISL cost to a value outside of the recommended range:
switch:admin> linkcost 1/9 32766
The link cost entered may prevent some parts of the fabric
from being accessible. If you do not want this to happen, choose n|no
and run 'linkcost' again with a value lower than 32766.
Do you want to continue? (yes, y, no, n): [no]y
switch:admin> linkcost 1/9
Interface1/9 (E_PORT) Cost 32766 (STATIC)
To set the ISL cost to the maximum value:
switch:admin> linkcost 1/9 65535
The link cost entered will cause the port to become unusable.
If you do not want this to happen, choose n|no
and run 'linkcost' again with a value lower than 65535.
Do you want to continue? (yes, y, no, n): [no] n
SEE ALSO
,
,