Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual
Page 906
876
Fabric OS Command Reference
53-1003131-01
portPeerBeacon
2
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
slot
Specifies the slot number on which the port peer beaconing is available.
port
Specifies the number of the port to be configured, relative to its slot for bladed
systems. Use switchShow for a list of valid ports.
--enable
Enables the port peer beaconing on a particular port.
--disable
Disables the port peer beaconing on a particular port.
--show -all
Displays the ports on which the Port Peer Beaconing is active. It helps to find the
ports that receive the ELS and start beaconing. The administrator can verify the
connectivity from the Telnet instead of physically verifying the connection.
--help
Displays the command usage.
EXAMPLES
To enable the port peer beacon on a port:
switch:admin> portpeerbeacon --enable 2/15
To disable the port peer beacon on a port:
switch:admin> portpeerbeacon --disable 15
To display the status of the port peer beacon on a chassis:
switch:admin> portpeerbeacon --show -all
portPeerBeacon is enabled on port : 2/15 in logical switch : 128
To display the trunk port port peer beacon information:
switch:admin> portpeerbeacon --show -all
portPeerBeacon is enabled on trunked ports :10,11 of switch :10
SEE ALSO
,