Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) User Manual
Page 645
Fabric OS Command Reference
615
53-1003131-01
nbrStateShow
2
ROUTABLE_SEND
The port is preparing for local route update; negotiates for the necessary locks
before updating the routes.
ROUTABLE_TIMER
The request for one or more locks failed; delay for a short interval before retrying.
DONE
The port is online and in use.
DECOM_START
The decommissioning request is sent to the neighbor and waiting for a response.
DECOM_WAIT
Waiting for neighbor to remove routes using the interswitch link (ISL).
DECOM_SEND
Preparing to update routes of the local port; negotiates for the necessary before
updating the routes.
DECOM_TIMER
The request for one or more locks failed; delay for a short interval before retrying.
DECOM_DONE
The local routes are updated; waiting for acknowledgement from the neighbor.
DECOM_BLOCK
The local routes are updated; the neighbor sent acknowledgement.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
This command has the following operands:
slot
For bladed systems only, specify the slot number of the port to display, followed by
a slash (/).
port
Specify the port number to display, relative to its slot for bladed systems. Use
switchShow to list valid ports. This operand is optional; if omitted, all neighbor
states are displayed.
EXAMPLES
To display information about a neighbor directly connected to the local switch:
switch:user> nbrstateshow 2/0
Local Domain ID: 1
Local Port Domain Remote Port State Sub-State
-----------------------------------------------------
16 2 48 NB_ST_FULL DONE
SEE ALSO