Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 1100)

1070 Fabric OS Command Reference
53-1003131-01
snmpConfig
2
linkRLIRFailureIncident: NO
HA-TRAP: NO
fruStatusChanged: NO
cpStatusChanged: NO
fruHistoryTrap: NO
ISCSI-TRAP: NO
iscsiTgtLoginFailure: NO
iscsiIntrLoginFailure: NO
iscsiInstSessionFailure: NO
IF-TRAP: NO
linkDown: NO
linkUp: NO
BD-TRAP: NO
bdTrap: NO
bdClearTrap: NO
MAPS-TRAP: YES
mapsTrapAM: YES
T11-FC-ZONE-SERVER-TRAP: NO
t11ZsRequestRejectNotify: NO
t11ZsMergeFailureNotify: NO
t11ZsMergeSuccessNotify: NO
t11ZsDefZoneChangeNotify: NO
t11ZsActivateNotify: NO
Note: The Zone Mib parameters are for restricted usage only.
To restore the systemGroup configuration to default values:
switch:admin> snmpconfig --default systemGroup
*****
This command will reset the agent's system group
configuration back to factory default
*****
sysDescr = Fibre Channel Switch
sysLocation = End User Premise
sysContact = Field Support
authTraps = 0 (OFF)
*****
Are you sure? (yes, y, no, n): [no] y
To set the security level:
switch:admin> snmpconfig --set seclevel
Select SNMP Security Level
(0 = No security, 1 = Authentication only,
2 = Authentication and Privacy, 3 = No Access): (0..3) [0] 1
Select SNMP SET Security Level
(0 = No security, 1 = Authentication only,
2 = Authentication and Privacy, 3 = No Access): (1..3) [1]
To display the SNMP3 configuration with informs disabled (in the example, the Engine ID in the user1
entry corresponds to the engine ID of the trap manager in Trap Entry 2: 10.103.5.105):
switch:admin> snmpconfig --show snmpv3
SNMP Informs = 1 (ON)
SNMPv3 USM configuration:
User 1 (rw): snmpadmin1