Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 250)

220 Fabric OS Command Reference
53-1003131-01
cryptoCfg
2
--show -container
Displays all CTCs in the encryption group. This command is valid on all nodes.
The following operands are supported:
-all -cfg
Displays the configuration for all containers in the encryption group.
-all -stat
Displays the runtime status for all containers hosted on the local node only.
crypto_target_container_name
Displays information for the specified CryptoTarget container. If the -stat
parameter is specified with this operand, the CTC must be hosted on the local
node.
-cfg
Displays the configuration for the specified CTC.
-stat
Displays the runtime status for the specified CTC.
--show -tapepool
Displays configuration information for specified tape pools when used with the
-cfg option. Displays runtime status information for specified tape pools when
used with the -cfg option. This command is valid on all nodes. The following
operands are supported:
-all -cfg
Displays configuration information for all configured tape pools in the encryption
group.
-all -stat
Displays runtime status information for all configured tape pools in the encryption
group.
-label pool_label | -num pool_num
Displays tape pool configuration or runtime status information for a single tape
pool specified either by a tape pool label or a number. These operands must be
used with either the -stat or the -cfg option.
-cfg | -stat
Displays either configuration information or runtime status for the specified
tape pools.
--show -LUN
Displays Crypto LUN configuration or runtime status information for a specified
CTC. This command is valid on all nodes. The following operands are supported:
crypto_target_container_name
Specifies the CTC for which to display the Crypto LUN information.
LUN_Num
Specifies the number of the LUN for which to display information.
initiator_PWWN
Specifies the PWWN of the initiator.
-cfg | -stat
Displays either the configuration or the status of the specified Crypto LUN. The
configuration can be displayed on any node in the encryption group. To display
LUN status, the specified LUN must be hosted on the local node.