Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 927)

Fabric OS Command Reference 897
53-1003131-01
portShow
2
OPERANDS
This command has the following operands:
slot
For bladed systems only, specifies the slot number of the VE_Port to be
displayed, followed by a slash (/).
ve_port
Displays information for a single specified FCIP tunnel. On the Brocade 7800,
Brocade 7840, or FX8-24, specify the VE_Port number associated with the tunnel
configured on one of the GbE ports. VE_Ports are numbered 16-23 on the
Brocade 7800 and 12-31 on the Brocade FX8-24 blade.
all
Displays information for all configured FCIP tunnels.
fciptunnel
Displays configuration and status per FCIP tunnel. The following operands are
supported with fciptunnel and fcipcircuit.
-c | --circuit
Displays the FCIP circuits within the tunnel. This operand can be used with any
other operand to include circuit displays.
-t | --tcp
Displays the TCP statistics for the circuit. The -c option must be specified with this
option.
--reset
Displays time based set of statistics.
--lifetime
Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the
associated TCP connections. This option will ignore any time based deltas
that were created previously set using the --reset option.
-p | --perf
Displays additional performance information for the specified FCIP tunnels.
--lifetime
Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the
associated TCP connections. This option will ignore any time based deltas
that were created previously set using the --reset option.
-q | --qos
Displays the QoS statistics including performance for each priority. This operand
is optional with the --perf option.
-C | --config
Displays only the configuration information
-i | --ipsec
Displays IPSec status (enabled or disabled) and key if enabled. If IPSec is
enabled and configured in legacy mode, the mode information is displayed in
parenthesis. This option is valid for portShow fciptunnel only. This option is
deprecated but still recognized. Use the -C | --config option instead.
-h | --hier
Displays the FCIP tunnel hierarchy listing basic circuit IDs and TCP connection
information for the tunnel.